Hello, I have the following problem. I wanted to print ASA with my Snapmaker and heated the heating bed to 100°. The magnetic plate of the printing bed curved upwards and had an air bubble in the middle under the printing plate. Has anyone ever had this problem and what can I do about it? I heated up the magnetic plate and didn’t put it on until the end. Kind regards, Luke
Did you try to turn around?
The idea is too simple to think of…I’ll test it
I printed Asa successfully at 85deg on stock plate with enclosure. Just cleaned it with alcohol. 100deg is a bit too much for it, plastic starts delaminating.