Hello everyone, I am looking for people who have already printed Polyterra Polymaker filament. I have a problem with this filament, on the PEI surface of the plate, despite degreasing with hysopropyl alcohol, it has difficulty adhering, on the smooth side it is much better but almost impossible to remove from the plate without damaging the part. Do you have any feedback on this subject? It is only with this filament that I have this problem. Thank you and have a good end of vacation to those who are still there.
For the smooth PEI, let it cool down fully, then spray a little alcohol at the edge and gently lift. The IPA will help release it.
Thanks for this feedback Skreelink! I will do the test when I get back from vacation and keep you informed!