Nozzle heat...?

So, I finally got to the point of where I thought I’d be able to start printing. Got my test file all loaded and ready to go. Hit start. Nothing happens. I noticed the nozzle wasn’t heating up. Checked the settings and it shows like a 195 C setting. So I tried to “load new filament” and get the nozzle to heat up. It did. Then I clicked start and the nozzle cooled down. Is it the file? Is it my settings (which I only messed with to turn off the heated bed because mine was damaged in shipping)? I’m lost…

Figured it out. Bad file.