I was running a couple of prints then the filament stopped extruding. I started a new print and it lays down a few layers but again it stops but the printer head keeps moving. I check the nozzle temperature and it was still at 205. [IMG_2481 (1)]

Wrapping the filament around the Z axis is going to cause problems. It’ll start feeding, then get too much tension for the extruder to pull on it. Even without that loop, people have issues with the filament binding and causing extrusion issues. You can find some filament routing mounts on thingi…

Why are you printing so far in the corner? The most accurate and consistent place to print is the middle. If it’s not the filament binding it could be that you’re printing too close to the surface and it’s keeping the filament from coming out properly. When this happens the gear starts grinding at…

This is happening for me also, 100% of the time. Every print (without a filament wrap), especially from when I put the Snapmaker inside the enclosure and it changed the filament load point. I would need to actually be able to print something in order to print filament mounts. I was hoping that so…

Try raising the Z-offset a little.

Also try a different filament. If it’s gone bad it can become brittle and won’t feed properly. You can also try raising your nozzle temp. Higher temp makes it flow more easily(think of warm honey vs. cold) -S

The PLA is not feeding into the nozzle.

Is the tube that the filament feeds into after the gears blocked? If so, heat up the nozzle to 10 deg above what you’d normally use for that filament. If you can grab some filament and pull it out do so. Or see if you can manually thread and force filament into the hole. If you can it should star…

On top of the other (good) suggestions here - in Luban turn the ‘Retraction’ down to 1mm from the default 5mm, and a bit slower like 40 vs. 60 speed. With retraction too high I think everytime it does a non-extrusion move it ends up starving the nozzle more and more. You can turn your ‘adhesion’ s…

Thanks for all of your suggestions. I tried heating up the nozzle to 250 and pushing the filament through and finally got it cleaned out flowing smoothly but when I tried another print using the recommended changes in Luban. I kept the top of the enclosure off so I could make sure the PLA was rollin…

At a certain point there gets to be build-up that just won’t come off inside the nozzle. Especially if you’ve had to heat up the filament beyond it’s normal suggested range. Particularly if you’re switching between various types. Like an oven or bbq stuff just gets carbonized and burnt on. Nozzle…

No filament is coming out after the start

Snapmaker 2.0 (3-in-1)

Jesi15 October 10, 2020, 5:12am 15

This thread might be of some use, there is a lot of good discussion about similar issues.

Topic		Replies	Views
Multiple printer issues that seem related Snapmaker 2.0 (3-in-1)	4	357	December 30, 2021
3D filament melts before it gets to the nozzle Snapmaker 2.0 (3-in-1)	9	718	January 1, 2021
Filament Feed Issue Snapmaker 2.0 (3-in-1)	11	1300	April 6, 2024
Printer Nozzle Jamming Snapmaker 2.0 (3-in-1)	18	1505	January 23, 2022
A350 not loading filament - brand new printer Snapmaker 2.0 (3-in-1)	9	1149	October 2, 2020

No filament is coming out after the start

Related topics