[17078645212341611656998843587744] This is first. Any idea what causes this? This was printed with fast settings. Secondly whats going on with this benchy? This was printed with strong and precise. [17078646473386298110157517022475] [17078646713848426723639036226331] [17078646884468116651515931937996]

The first photo: I have no idea what you’re referring to. What exactly is wrong? Did your print split up? If so, most likely you had a temporary nozzle clog. Benchy: Would guess you’re printing too hot, but I may be wrong. Perhaps your nozzle needs a good cleaning. I find these pages helpful to analyze problems: Print Quality Guide | Simplify3D Software

Yeah, it split I don’t think it’s a nozzle clog as others have split with the fast setting. My first benchy split as well. They don’t split when I use strong and precise but that takes a lot longer. I’m trying to dial in my settings. I’ll take a look at that guide you posted though.

I am using a single extruder so I’ll take a look at that too. I did just order the dual extruder. Does this apply to that as well?

For me, the dual extruder was dead-on with factory settings, while the single extruder was underextruding and needed E-steps-adjustment.

Need some more help

Snapmaker 2.0 (3-in-1)

Hauke February 14, 2024, 2:32pm 4

If you are using the single extruder, calibrate your E-Steps: Summary: Extruder calibration a must

Topic		Replies	Views
Help Printing A Benchy Snapmaker 2.0 (3-in-1)	24	788	November 4, 2024
Help what direction to take with bad dual-extrusion prints Snapmaker 2.0 (3-in-1) Dual-extruder	25	527	November 8, 2025
Help Qualitaty Check with a Benchy Snapmaker 2.0 (3-in-1)	14	323	June 21, 2025
A350 with dual extrusion head will not print Snapmaker 2.0 (3-in-1)	29	434	November 7, 2026
Poor print quality on most extreme right surface of all prints Snapmaker 2.0 (3-in-1)	8	154	February 18, 2025

Need some more help

Related topics