I did some light 3d printing last week and had no issues for the record. Earlier though I was turning it on to load some new filament and start a run of holiday project prints for my sons school class, however I’m dead in the water right now. The touch screen started giving the “min temp err” and th…

Min Temp Err at Random, NA at Random on Board and Nozzle

xchrisd April 14, 2020, 5:33pm 10

JKC20 has edited the link above, have you updated to luban?

Topic		Replies	Views
Nozzle shows NA Snapmaker Original	3	995	September 1, 2018
First print problems - faulty heated bed Snapmaker Original	3	776	December 19, 2021
Heated bed: NA°C after a few prints Snapmaker Original	4	1072	August 2, 2018
Waiting 0% Error - Temp issues? Snapmaker Original	12	1568	March 5, 2018
Print module and Heated bed non responsive Snapmaker 2.0	3	370	June 1, 2022