Laser module edge burn

[brent113]

This is to get it connected to the Snapmaker without the firmware modification I made. It’s a bit of a learning curve as it’s different than Luban.

Lightburn Device Flavor - "Snapmaker", not "Marlin"

EDIT: There’s a much easier way to do what I was trying to do, and that would be properly configure Lightburn, ha. Leaving the post up for posterity with the newer instructions A new Lightburn device needs to be created using the Snapmaker language variant. When I originally set it up I chose “Marlin” instead of “Snapmaker”. Lightburn correctly generates the required S and P parameters when using a “Snapmaker” type device. [image] [image]