Issues with my snapmaker 2.0 3D Printing

[xchrisd]

Check your cooling settings, minimum layer time, here is a Google search:

https://support.makerbot.com/s/article/1667417947135

The snapmaker pla is not the best choice because of badly print finish in the past.

I printed it with 190°C in the beginning…

Here is an forum thread for reading:

Snapmaker Tower Tips! (Images included)

Hey all! If you’ve tried to make a small tower with the snapmaker, you;ve probably noticed the walls look terrible and it isn’t setting properly. [Album] Imgur [Imgur] Figure 1: It’s difficult to see, however, the print has unevent sides and caved in sections. What causes this? This is caused by the nozzle never having time to …