Hallo, I searched on the forum but couldn’t find anything about it. Is it possible to turn off the prime tower in Luban? I’m also wondering, maybe is a stupid question, but why the prime tower is necessary when printing with the dual extruder using only two colors. I’m working with the Artisan. T…

I currently am not sitting in front of my computer, so I cannot give you an answer to the “can I switch it off in Luban” question, although I would assume that somewhere in the expert settings that should be possible. But what I want to emphasize is that the prime tower in my experience unfortunate…

Also not in front of Luban, but all of what @Hauke said. ^ The prime tower switch is certainly available in Cura, and may be a hidden expert setting in Luban as well. But yeah, I’ve only had a few prints that I was able to get away without using one. Usually it’s best to leave it on.

Looked for it - here is where you can control it in Luban: [grafik] Then: [grafik]

Thank you for all the replies. I now understand the purpose of the tower better, and I have finally found the setting to switch it off. The reason for turning off the tower was more a question of time than saving material. But after what you said, it is probably better to let it on.

Is it possible to turn off the prime tower

Software Snapmaker Luban

Topic		Replies	Views
Why Prime/Wipe Tower always both colors? Snapmaker Luban	2	500	April 22, 2023
Extra object problem Snapmaker Luban Gcode , 3D_Models , Snapmaker_Luban , Dual-extruder	1	252	December 28, 2023
Unusual object when using support Snapmaker Luban	3	822	August 17, 2023
Is there a way to incorporate Luban features into orcaslicer? Third Party Software	6	145	November 3, 2024
First Print - Why is a Cylinder part of the print for the Pen Holder? Artisan (3-in-1)	5	583	March 31, 2026

Is it possible to turn off the prime tower

Related topics