Hello ! What do you use to maintain your Snapmaker in good condition ? Do you add oil on axis ? Do you you use special grease for crews ? Where can i find official advises from snapmaker ? Does it exist ? … I’ve found absolutely nothing about that. Thank a lot for your advises… it’s my first 3d p…

OK, thank you for that information :+1:

Hi All, Is this a maintenance issue to keep on top of, is this a faulty part or is this ‘normal’ wear and tear of the nozzle. [leaking hot end clean up bottom] [leaking hot end clean up top] [leaking hot end clean up] [temp sensor melted]

This is a bad assembled hotend,- there should no filament run out near the thread. If you do a bit googleing, you will see that you have to fasten the nozzle after preheating the hotend. This is kind a normal, if you didn´t care or didn´t knew it.

is there another type or brand which is ok? (the nigi FG-107m is acutally not available) Silicon or silicon free?

this was ‘box fresh’ I had assumed everything should be ready to go from the spares pile. I have cleaned up the nozzle and attempted to reuse but it is still leaking under pressure. I have contacted support and have some replacements on the way.

Could you please tell me which agent replied to your ticket? Or did your issue get resolved now?

@Mr_Fen Several simple questions for you. Is this thing the white filament? [image] Is this the black filament? [image] Does this issue happen when you used the hot end for the first time? Looking forward to your reply.

I was using black filament for a couple of prints and then swapped it to white. When I noticed the white coming out around the nozzle I pulled the hot end out and spotted the black had oozed out the top.

‘Potter’ has been working on the ticket for me.

I found this on Amazon. Molykote EM 30L grease. It’s a DOW PAO grease for plastics. Gunna order some to have on hand. [image] Dow Corning Molykote EM-30L Synthetic Grease Lubricant, 1oz Container.:... Dow Corning Molykote EM-30L Synthetic Grease Lubricant, 1oz Container.: Industrial Lubr…

How to maintain the snapmaker in perfect condition?

Snapmaker 2.0 (3-in-1)

MooseJuice January 19, 2021, 2:35pm 32

Yes thats fine. White lithium grease is what you want.

Snapmaker 2.0 A350T lead screw greasing to reduce the squeaking noise in Y-axis movement

Topic		Replies	Views
Lubrication of the linear modules Original (3-in-1)	8	4930	July 28, 2019
Maintenance tips? Snapmaker 2.0 (3-in-1)	4	1302	July 13, 2021
A350 Service for linear moduls neccessary? Snapmaker 2.0 (3-in-1)	1	1143	December 22, 2020
Maintainance Support (squeaky noise) Snapmaker 2.0 (3-in-1)	2	411	October 15, 2023
Preventive Maintenance Showcases & Tips	1	792	January 7, 2021

How to maintain the snapmaker in perfect condition?

Related topics