I recently purchased an A350 and was somewhat surprised to read that the firmware is compiled without the codes for pausing a job. Am I correct in understanding that the firmware in the public repository will enable that function? Is there any downside to compiling and flashing it? I want to precise…

[image] chemist: Am I correct in understanding that the firmware in the public repository will enable that function? At this time, no, assuming you’re referring to M0, M1, M108, M112, or M600. There has been limited discussion related to adding these functions, but it’s not trivial to do and …

Thanks for the response. I see that you’ve been very involved in this discussion.

Just update the command M600. [image] M600 manually injected pause for color change failures Snapmaker 2.0 Users can refer to this article to use M600 in your gcode file.

Github firmware question

Snapmaker 2.0 (3-in-1)

Edwin April 29, 2021, 7:22am 4

Just update the command M600.

Topic		Replies	Views
Does Snapmaker support pause at layer? Snapmaker 2.0 (3-in-1)	26	4292	January 16, 2025
M600 manually injected pause for color change failures Snapmaker 2.0 (3-in-1)	27	3832	July 12, 2022
When? - Pause/resume feature (Marlin or otherwise) Snapmaker 2.0 (3-in-1)	1	787	December 5, 2021
M600 command for Snapmaker Original Original (3-in-1)	5	884	August 5, 2022
No stop for filament change Snapmaker 2.0 (3-in-1) Gcode	23	665	November 14, 2025

Github firmware question

Related topics