Hello, Would you if there is a set of command in lightburn which would turn the enclosure fan on at the beginning of a laser job and then stop after 15s once job in completed. Thanks Alban

There are G-codes for enclosure fan control. See this thread. [image] FYI: Custom Snapmaker 2 GCODES - Enclosure Control, Customize Parameters, Information & Debugging Snapmaker 2.0 In Snapmaker 2 there are custom GCODE commands, not standard in Marlin and not documented,…

…which apparently don’t work with the Artisan. You’d think that 2.0 and Artisan would have the same G-code commands.

If it is the same as SM 2.0 ; Fan Air to 100% M1010 S4 P100 Air purifier ; see AirPurifier gcode: https://snapmaker.github.io/Documentation/gcode/M1011M1011 ; choose between F1, F2, F3 gear working M1011 F3 S1 Off ; wait 120 seconds G4 S120 Fan ; Fan Air to 0% M1010 S4 P0 Air purifier ;Air …

Didn’t work for me, either sending a file with only that command to my Artisan or using the console in Luban. Is it possible it only works with certain modules?

Just as a very tardy follow-up, the Artisan uses its own G-code for the enclosure fan: “M2000 W2 P<power>”. I have verified that it works.

I am new to light burn and snapmaker, how do I get this code to work?

Hello, Command works fine, you can adjust speed from 0 to 100% in lightburn. Cheers

Well Im new to it and I have no Idea where to enter the g code or anything about it. I was wondering if someone could show me and explain.

Does anyone know the g code for the air purifier for the artisan?

M2000 W40 (Artisan) - Set Purifier Fan Gear Description Set the speed gear of the purifier fan. After setting the speed gear, the purifier fan may not necessarily turn on, because it also depends on its switch status. Usage M2000 W40 P<n> Copy Parameters P: gear, ranging in {0, 1, 2, 3}, 0 rep…

Gcode command for FAN in lightburn

Artisan (3-in-1)

TheBum April 28, 2024, 6:08pm 2

There are G-codes for enclosure fan control. See this thread.

Topic		Replies	Views
Artisan 40W Laser Control Using Lightburn Macros Artisan (3-in-1) Gcode , Laser	2	110	July 26, 2024
Ray and Lightburn - Activate and deactivate enclosure - how to stop enclosure fan Ray (Laser)	9	322	May 22, 2024
Feature request: Auto on/off exhaust fan Snapmaker2.0 Troubleshooting guides	2	1158	December 25, 2021
Ability to control lights & fan on enclosure mid-print Snapmaker 2.0 (3-in-1)	18	3869	May 7, 2021
Artisan Gcode for lightburn Artisan (3-in-1)	5	501	November 27, 2023

Gcode command for FAN in lightburn

Related topics