I’ve connect my A350 to my laptop via usb and while trying to enter in commands I’m continuously getting “others < Enclosure online: off” to the point any information I’m trying to look at is getting pushed so far back in the command log that I can’t view it. Has anyone else experienced this issue? If so there any solution as to getting it to stop?
i get this too, every 4th line the enclosure off appears. But just with luban…
I actually look at my testprint, printing via touchscreen and hearing the serial monitor with simplify3d and/or luban.
We have noticed this issue and this is because the new Snapmaker Luban that is matched with the firmware is not released these days. The corresponding version of Snapmaker Luban will be released this week.