I recently replaced the dual extruder covers on my Artisan. Now I receive an error 13-15 Extruder R failed to home. However, I can manually move the extruders through full motion using the control unit motion buttons. WHY?
Does the blue light come up when the right hotend moves up?
Yes, both blue lights are on. However, I found the problem. On the control board sockets was poorly attached to the control board and has come loose from the control board. I’m trying to repair it, but the contacts and the solder area is so small that it may not be practical.
I’m now awaiting a quote for either a whole new extruder (without hot ends) or just a new control board.
Regards,
Lew Palmer
(attachments)
1 Like