Dual Extruder and CURA

[michaelapp]

Hello all,

I have created a profile for my Snapmaker A350 and the Dual Extruder.

When extruder 1 is done printing, it is lifted, then extruder 2 starts moving the plastic out and only then moves to the tower.

What do I need to set up so that it goes to the tower first and then extends the plastic?

Regards
Michael

[Burgerboy]

Searching the forum helps

Cura & Dual Extrusion head first try

Hi folks, just finished my first dual color print with the dual extrusion head. I started off with Luban, and quickly stopped. Although many Cura settings are by now available in Luban, important ones are missing. In Cura, I created a new printer with the following settings (not strictly true - I modified start/end code after the print, so take it with a grain of salt): [grafik] [grafik] [grafik] The extruder start/end-GCode is of no effect, but allows you to locate the extruder changes…