Current status of SM 2 Octoprint support for Fiment Runout Detection

[nivekmai]

Coincidentally, I was working on this basically the exact day you asked @peregrin5 (it took me a few days to get everything working consistently)

[GUIDE] Octoprint + (stock) Filament runout detection

I finally sat down and worked through getting runout detection working in octoprint using the stock sensor, so I figured I should put it up here in case others want it as well. Prerequisites You must set your slicer to use relative extrusions. I use Prusaslicer, and the setting is called “Use relative E distances”. IHNI if luban supports it, but let’s be honest, if you’re using octoprint, you’re probably not using luban You should have octoprint set up already, and understand ho…