Hi to all!! i use Snapmaker Ray and lightburn Software. After the end of the job, the crosshair laser is switched off How can is switch on?? (After shut off the Laser and swicht on the Crosshair is active!, but it is not very confortable) regards Helmut

https://wiki.snapmaker.com/en/snapmaker_ray/troubleshooting/crosshair_offset [image] Using Artisan with LightBurn Snapmaker Artisan Reading the lines of the settings, they’re all setup as GRBL machines. The 2.0 and Artisan run on Marlin, the Ray is GRBL. I’m going by the …

So, I banged my head against this for a short while, as the command line they say turns on the laser didn’t work for me. However, I found a much more convenient work around. As you said, the crosshair is on until you do your first job and then it goes off. All you have to do when you walk up to t…

Cross line laser

Ray (Laser)

xchrisd February 8, 2024, 7:02pm 2

https://wiki.snapmaker.com/en/snapmaker_ray/troubleshooting/crosshair_offset

Topic		Replies	Views
Show Crosshair on 40w laser when framing in lightburn Artisan (3-in-1)	3	850	March 27, 2024
Snapmaker Ray + Lightburn Ray (Laser)	13	1597	July 21, 2024
Urgent Support please! I have a 40w laser and the crosshair is not coming out Ray (Laser) Laser	3	99	March 14, 2025
40w S2 Laser cross hair and laser cut spot Snapmaker 2.0 (3-in-1)	6	688	April 21, 2024
1064nm IR+20/40W + Lightburn Guide Snapmaker 2.0 (3-in-1)	125	7965	April 29, 2026

Cross line laser

Related topics