I would like to add a driver cooler to the system and would like to use the daisy chain of the LED stripes of the U1. Of what type are the connectors? Thanks in afvance Roy

I have seen this, thanks! But the connectors are unfortunately not mentioned there. As I am switching the LED on for printing and shutting them down 5 min. after the print is finisched, I would like the power source from the LED strip of the printer to cool the stepper driver during printing only. …

According to https://wiki.snapmaker.com/en/snapmaker_u1/troubleshooting/LED_strip_replacement_guide it looks like a JST connector. JST PH 2.0mm or JST XH 2.54mm if I would take wild guess. I would contact support to confirm with them before.

Connectors on LED Strip

U1 Toolchanger

CrazyIvan May 20, 2026, 12:29pm 2

There are existing solutions in this thread: Treibertemperatur

Topic		Replies	Views
LED Connector cable Artisan (3-in-1)	1	88	August 6, 2024
U1 extension cable for the filament feeders U1 Toolchanger	23	2760	June 1, 2026
Stepper Motor Smoother Board (Diodes) / Linear Module Pinout? Original (3-in-1)	4	2299	April 25, 2019
6 pin connector on the upper back side U1 Toolchanger	6	253	May 7, 2026
Any powered ports for LED on A350T? Snapmaker 2.0 (3-in-1)	4	618	January 27, 2022

Connectors on LED Strip

Related topics