I would like to add a driver cooler to the system and would like to use the daisy chain of the LED stripes of the U1.
Of what type are the connectors?
Thanks in afvance
Roy
There are existing solutions in this thread: Treibertemperatur
I have seen this, thanks!
But the connectors are unfortunately not mentioned there.
As I am switching the LED on for printing and shutting them down 5 min. after the print is finisched, I would like the power source from the LED strip of the printer to cool the stepper driver during printing only.
I will use an in-line connector for the 24V cable of the LED and a step down (LM 2596) to run a 92mm Noctua fan.
According to https://wiki.snapmaker.com/en/snapmaker_u1/troubleshooting/LED_strip_replacement_guide it looks like a JST connector. JST PH 2.0mm or JST XH 2.54mm if I would take wild guess. I would contact support to confirm with them before.