I have A350, i upgraded the rails and head, firmwares auto updated, i noted that the numbers in M501 were different, assumed that was right because of upgraded rails and head. I have been having odd printing issues (severe under extrusion on first layer) and i am struggling to know what changed bec…

Confused on settings after executing M502

brent113 January 5, 2022, 10:46pm 7

Try M502, then M500 to save, then power cycle? M502 used to immediately write to EEPROM but I’m not seeing that at the moment.

Horrible grinding noise on Y Axis after new LM Install

Topic		Replies	Views
Question about New Linear Rails upgrade? Snapmaker 2.0	5	880	October 17, 2022
Things that change with doing a firmware-update Snapmaker 2.0	8	973	May 15, 2021
Calibration Issues After Update Snapmaker 2.0	7	1469	December 12, 2021
Reset to factory settings did not retain information about Dual Head Extruder Snapmaker 2.0	2	473	August 1, 2023
Extruder Calibration a must Snapmaker 2.0	285	42825	July 1, 2024