clewis
October 25, 2022, 10:00pm
2
These aren’t my guides, but I post links to them a lot:
First of all, congratulations to a great machine!
If you have any suggestions to this topic, feel free to send me a PM!
You are new to 3d printing?- Be patient. The whole thing is very complex and just little adjustments will make the difference from failed to pretty prints.
Start with easy, little things to create (1-3hours i would suggest) . Going to print the first time and then getting a 24h print on, maybe failes.
There is a lot to learn, if it didn´t work for a long time, cool off a bi…
I noticed that there’s no guide specifically for setting up octoprint on the original snapmaker here. I’ve done this for my A350, and just got an original, so I figured I’d put one together since there were a few things I had to look up in the process.
The process is relatively simple, most of what you need was already included with the machine.
NOTE: This setup will take you through a few things before connecting your machine, we’ll first want set up octoprint, and only connect to the machin…
IIRC, the forum has a mode where you can make your post edittable by other people. I’m not sure how, but SnapLinks -- Wiki is an example. Actually, that’s probably a good one to add too. It’s not a guide per se, but it has a lot of guides linked.
2 Likes