Can't even figure out sample project

[Edwin]

It seems that you need to adjust the laser height on the touchscreen.

Here is an article for your reference:

What should I do if the light of the Laser Module is weak?

Our technical writer team plan to release a Snapmaker Luban tutorial. But, the software user interface changes a lot, it is difficult for me and our TW team to write the tutorial.

Please let me know what do you like to know, the parameter definitions or the laser settings?

Here is an article for your reference:

Snapmaker 2.0 Laser engraving settings

Preface This report is primarily concerned with methods for optical calibration of laser engraving module. Light power is very important for the laser engraver, not clear standard has been established for the calibration procedure nor requirements of power meters suitable for optical power calibration. The purpose of the report is to provide guidance for establishing calibration procedures. Category Beechwood MDF More to be posted Pattern definition Work speed: The speed at which the la…

Cheers
Edwin