Achieving a good first layer A350

[Dojima]

Now that it’s working better, here is a 25 hour multi part print:

Flying Sea Turtle, A350 25 Hour Print

If you’ve seen any of my other posts you will see I’ve spent most of my A350 life trying to work through issues. However, I’ve reached a point that I think I can try printing something a bit more than a calibration cube or benchy So going for this awesome Flying Sea Turtle. I don’t have any nice monitoring setup like Octoprint so helpfully it all goes well. Settings: Layer Height: 0.16mm Infill: 15% Flow Rate: 90% Default Printing Speed: 30 mm/s Hotend: 195C / Bed: 60C …