3db bug: wont save gcode in Preview view after initially using workspace to rename suggested gcode file and sending gcode to device

Software Snapmaker Luban
1

Recreation steps (A350 over wifi already pre-authorised but not last pc connected):

  1. open luban in 3dp mode
  2. load 40mm stl
  3. Set material to PETG (240 initial, 235c normal printing)
  4. Generate and export to Workspace
  5. cancel suggested preview dialog with send to luban option (device auto-connects)
  6. rename workspace file
  7. send to device
  8. go back to preview
  9. try to save gcode (FAILS) - no file written / dialog.
  10. go back to workspace and export file there (SUCCESS) - file written and dialog confirms.
  11. go back to preview and export file there (FAILS again) - no file written / dialog.

There was a “recent file” shortcut listed in Windows Explorer after step 9 for the gcode file, but selecting it said file not found, so it’s possibly being removed silently after a failure.
40Connector.stl (71.8 KB)

1 Like