1064nm IR+20/40W + Lightburn Guide

[Skreelink]

Plopping my new alignment corners here, a bit more reliable than what I was using.

Updated Laser Corners

Finally got around to modeling up my own corners for laser alignment. These are more dependable and repeatable than the other ones I remixed and have been using. Figured I’d toss them here on the forums for others to use and so I can recommend them in my laser guides. Keep in mind I made the tolerances quite tight because of the friction fit, you may have to tune your printer to get them to fit properly. A350/T Version; A250/T With Quick Swap; The A250 one aligns using pins to fall into th…