Terrible lines on print

[xchrisd]

OK, I see you want to push to the maximum.

At this point, you have to start a bit smaller and easier.
Try to print it with 0.12 Layer height (or a other multiple of 0.4mm, search for magic number if you are interested) and see if you want to push further.

I don’t want suggest you to calibrate your machine after the first print. - It would be good, but normally beginners don’t need to.

Anyway your walls are pretty slow, you don’t need to print that slow, 20mm/s would be ok for this details I guess.

I would suggest to have a look at this:

3d Print Guide_Walk Through

First of all, congratulations to a great machine! If you have any suggestions to this topic, feel free to send me a PM! You are new to 3d printing?- Be patient. The whole thing is very complex and just little adjustments will make the difference from failed to pretty prints. Start with easy, little things to create (1-3hours i would suggest) . Going to print the first time and then getting a 24h print on, maybe failes. There is a lot to learn, if it didn´t work for a long time, cool off a bi…