Teaching Tech Calibration Gcode

[brent113]

Good question. None is needed since it’s enabled automatically at startup, that is the setting “No ABL”.

You are also correct that M420 S1 is the command to enable the bed leveling mesh if somehow it was disabled.

@eacmen

If anyone else has tried his gcode I would like to know

Funny you should ask

Snapmaker 2.0 Initial Calibration Settings / Experiences

Hello all, I thought I’d type up my setup and calibration procedures for future reference since I haven’t seen too much of this information in a single place before. Hopefully this is useful. There are other introductory posts worth reading such as: @xchrisd’s 3d Print Guide_Walk Through The first thing I did was update to the latest firmware, change the auto bed levelling to 5x5 grid, and do an auto level. I’m impressed with this process, it works pretty smoothly. Looking ahead, I’ve fou…