Taller Builds knocked off by X-axis arm

Original (3-in-1)
13

Hi Pineduhh,

Here I attach a file. Please try to run the gcode file.
When you run it, please check whether the Z goes to the half way. If it does, please swap the X and Z axis to try again.
After exchanging them, if it works well, the issue is related to the Z-axis.
If the issue still exists after exchanging, we need to further analyze the issue.TT.gcode (557 Bytes)

4 Likes
After installing the z-axis extension. At the end of the output, the z-axis descends and spoils the output