I’ve been hunting for the specifications of the various parts of both SM and SM2. Hidden among several forum posts I’ve now found the official specifications page for both. Unfortunately I cannot include both the links here because my account is too new. The one hardest to find was the SM2 specifica…

@Edwin , supplementary question, the PDF you sent has an entry “Waterboard & Clamping Kits for CNC”, is that a typo, should that be “Waste Board & Clamping Kits for CNC”?

@Edwin Missing in @ITmaze ’s sheet and your doc is the speed of the linear modules. This detail is also a parameter of the Fusion 360 machine specification files. I’d appreciate it if you can get that info from your engineers.

@Anm , I’ve added a row for it, but I don’t yet have the actual specifications for it.

Sorry, @ITMaze , you are right. I saw that and meant the data was missing, not the row for the data.

Good morning all, First post to the forum here and a new Snapmaker owner/user but not new to 3d printing and CNC. I’ve been trying to find some information on the power consumption of the A350 in its different configurations, Printing, Laser and Milling. I can set up current probes and figure it…

[image] Buzzzjob: I can set up current probes Just go straight to that. The only information I’ve ever run across about current consumption is that the rate of heating the bed is limited by current capacity. (The heated bed uses DC that goes through the main power supply.) And that informatio…

Yes I saw the documentation glossed right over that. I will have to do three samples, one for each module. Right now I need the printer more than anything but once I get some numbers I’ll share to the group. Thanks!

When mine arrives I intend to do some measurements using a TP-Link HS110: https://www.tp-link.com/au/home-networking/smart-plug/hs110/ I also plan to leave that plug there so I can switch off the SM remotely at the power switch.

[image] Buzzzjob: three samples, one for each module There also five linear modules, a heated bed, the main controller, and a touchscreen. The Z-axis modules will typically have the highest loads of any of the linear modules.

Whoa i never saw that before, really cool!

Specifications Overview

Snapmaker 2.0 (3-in-1)

Atom December 11, 2020, 7:05pm 30

Here are some numbers from another thread:

Topic		Replies	Views
FYI Specs for Snapmaker 2.0 Snapmaker 2.0 (3-in-1)	16	1873	April 27, 2021
Snapmaker 2.0 A350 Power Supply Requirements Snapmaker 2.0 (3-in-1)	17	6587	June 2, 2021
Snapmaker 2.0 stepper motor drivers, noise and upgrade Snapmaker 2.0 (3-in-1)	37	6077	July 30, 2021
Is it worth it to buy a Snapmaker 2.0? Snapmaker 2.0 (3-in-1)	30	11432	November 10, 2020
Snapmaker 2.0 Electrical Specifications (Individual Parts - DC) Snapmaker 2.0 (3-in-1)	1	829	May 3, 2021

Specifications Overview

Related topics