Snapmaker 2.0 3D printing

Problem 3D printing Luban

Screen freezes ,Luban 4.3,2.

With Luban 4.1.3 it loads but slicing stops at 50%.
STL too big ? 435,493,884.

Have you tried slicing it with anything other than Luban? Cura, for instance?

Yes no problem with cura slicing

File a bug against Luban on Github, then (unless there already is one. There probably is, because other people have reported similar problems.)

Thanks for your comment. :+1:

Fixed problem just with the settings of CURA 5.0
for snap maker.

1 Like