Hey creators:) I’m new here and I’ve just finished my first print with the Snapmaker A350. My problem or question is now, how to remove the skirtline from the heatbead. I can’t get it off… The print itself went really well. Thanks for your help!

Thanks for your answer at first :slight_smile: I’ll try Isopropanol then. How can I disable the skirt in Luban? It seems I’m not allowed to. Do I have to make my own profile? Thank you :slight_smile:

I wouldn’t recommend disabling the skirt, entirely, you may get the first couple inches of extrusion in the first layer missing. Skirts help with priming the nozzle and making sure the flow is even before starting the important print. Other slicers can do a multi-layer skirt (2 layers high) that hel…

Just change it to 3. Then it does 3 skirt passes. Makes it a little thicker so its easier to get off and still get the benefits of it priming and being able to see that it’s flowing properly. -S

Also, if you run the same print again with a 3 or more skirt pass, it will stick to the old skirt you’re trying to get off and help you remove it. (stop it after skirt passes) You didn’t indicate you were having problems removing print, if you were raise your z-offset .05 -S

Thanks @sdj544 , that’s a good hint :slight_smile:

I know this isn’t popular opinion, but I hate skirts, I never use them. I will use a brim occasionally but generally I observe the first layer of the actual print and restart the print if I have major adhesion issues.

That’s a hot take I’m not sure I can support haha. JK <3 How do you ensure the nozzle is primed? I’ve had issues. The main issue is the priming most slicers generate automatically is done immediately after homing, and then as it travels down some inevitably drops out of the nozzle. I’m aware prim…

I have my slicer set up to prime while the nozzle is to the front left of the print bed. So it homes, heats, lowers to bed hight and front left, extrudes, then moves to starting position.

Would you mind sharing that gcode, please?

Remove skirtline from heatbed?

Projects, Tips & Mods Showcases & Tips

Atom October 13, 2020, 12:23pm 2

Check out this thread:
Cleaning bed tricks

Topic		Replies	Views
What's the use of a "skirt" in g-code Snapmaker Luban	7	2058	December 3, 2020
Luban outline project Snapmaker Luban	1	328	January 21, 2022
Primer line issue with partial heated bed Artisan (3-in-1)	4	232	January 19, 2024
Multi-layer skirt option Snapmaker Luban	8	753	May 21, 2021
Dual Extrusion Double Skirt Snapmaker Luban	3	440	March 20, 2023

Remove skirtline from heatbed?

Related topics