German:
Danke, für den Tipp.
Ich bin mir nicht sicher, ob ich das Ergebnis richtig auswerten kann.
English:
Thanks for the tip.
I’m not sure if I can evaluate the result correctly.
Send: M503
Recv: echo: G21 ; Units in mm (mm)
Recv:
Recv: echo:; Filament settings: Disabled
Recv: echo: M200 T0 D1.75
Recv: echo: M200 T1 D1.75
Recv: echo: M200 S0
Recv: echo:; Steps per unit:
Recv: echo: M92 X80.00 Y80.00 Z1600.00 E138.58
Recv: echo:; Maximum feedrates (units/s):
Recv: echo: M203 X350.00 Y350.00 Z10.00 E80.00
Recv: echo:; Maximum Acceleration (units/s2):
Recv: echo: M201 X10000.00 Y10000.00 Z500.00 E6000.00
Recv: echo:; Acceleration (units/s2): P<print_accel> R<retract_accel> T<travel_accel>
Recv: echo: M204 P3000.00 R10000.00 T3000.00 D50.00
Recv: echo:; Advanced: B<min_segment_time_us> S<min_feedrate> T<min_travel_feedrate> J<junc_dev>
Recv: echo: M205 B20000.00 S0.00 T0.00 J0.00 V5.00
Recv: echo:; Home offset:
Recv: echo: M206 X0.00 Y0.00 Z-13.03
Recv: echo:; Hotend offsets:
Recv: echo: M218 T1 X338.46 Y0.02 Z0.000
Recv: echo:; PID settings:
Recv: echo: M301 P18.30 I1.09 D76.75
Recv: echo: M301 P18.30 I1.09 D76.75
Recv: echo: M304 P49.96 I4.59 D362.77
Recv: echo:; Stepper driver current:
Recv: echo: M906 X1000 Y1400 Z1000
Recv: echo: M906 I1 X1000
Recv: echo: M906 T0 E800
Recv: echo: M906 T1 E800
Recv:
Recv: echo:; Driver stepping mode:
Recv: echo: M569 S1 X Y Z
Recv: echo: M569 S1 I1 X
Recv: echo: M569 S1 T0 E
Recv: echo: M569 S1 T1 E
Recv: echo:; Linear Advance:
Recv: echo: M900 T0 K0.02
Recv: echo: M900 T1 K0.02
Recv: echo:; Tool-changing:
Recv: echo: Z2.00
Recv: Heat bed center offset: X0.93, Y-1.26
Recv: M593 X P1 F50.00 D0.10
Recv: M593 Y P1 F50.00 D0.10
Recv: ok