I’ve noticed that when I have prints that go close to the front edge, and especially with fill operations that have front to back movements, the edge of the plate can rock at least a millimetre vertically, possibly more. As a result, I see less precision on the print in that area and more issues wit…

I’ve finally done the mod myself as well: [Snapmaker 2 linear guide mod] I’ve made some modifications to the adapter that was mentioned earlier in this thread so you can adjust the height with a nut: [DSC_2151 1] this makes the installation a little bit more convenient and easier to …

I had the same issue so installed some linear rails. I didn’t want to start drilling holes in the snapmaker base so made some new lower feet so the base was the same height as the enclosure bottom rail and used that to clamp to. Not the most elegant solution but it works. [Screenshot_20210610-1741…

I’d say that qualifies as elegant. Any plans or a parts list that you could share?

That it does, much better than any others I’ve seen.

@MonkeyHarris are those hgr 20?

Thanks for the kind comments. The extrusion is 2020 x 800mm long and the rails are HGR15 x 800mm long. I’ll dig out the sketches of the feet and clamp blocks this weekend and post them.

That’s great! The A350 has more space and you can place the slide rail, but has anyone tried hard with the A250? I’m an A250 and I’ve considered many things but haven’t been able to make it happen.

Just measure total length of the enclosure (without counting vent) and get the same rail but shorter length, everything else will be the same

Unfortunately, the A250 has almost no gap between the Y and Z axes, so a slide rail cannot be installed. We are looking for a better way, but have not found it so far.

Minimize rocking

Snapmaker 2.0 (3-in-1)

Zoli June 10, 2021, 4:28pm 2

i have a same… but more annoying on the cnc mode… i’m thinking to build or print a rail system under the carriage… both side of the table… hope fully this way the table get more stable

Cant get front to back Z alignment

Topic		Replies	Views
My new Snapmaker 2.0 A351 :grin: Showcases & Tips	54	9982	April 30, 2022
Full metal platfrom replacement for A250 and A350 with direct connect to SBR16 Rails Snapmaker 2.0 (3-in-1) Accessories	34	4415	November 21, 2023
A350 Linear Guide Rail Mod Snapmaker 2.0 (3-in-1)	15	7624	March 4, 2026
Shoring up the CNC module Snapmaker 2.0 (3-in-1)	33	3116	February 9, 2023
Why does an .2mm initial layer measure .4mm +? Snapmaker 2.0 (3-in-1)	59	2110	October 10, 2021

Minimize rocking

Related topics