M600 & Octoprint

Snapmaker 2.0
1

I have the latest firmware on my A350 which now supports the M600 change filament command. I also have OctoPi hooked up. I sliced a simple cube and put the M600 command at layer 2. If I print it through OctoPi it just keeps printing. If I print from a flash drive directly on the A350 it will trigger and let’s me change filament.

I was hoping I could have the same result via OctoPi. Thoughts?

2

maybe just use Rewrite M600 - For M600 Unsupported

3

I could but the new firmware supports the M600. It automatically kicks everything off on the LCD for swapping out the filament.

4

Yea, in my experience, using the touch screen and octopi in conjunction doesn’t work out too hot.