CalibrationTest.stl (71.4 KB) CalibrationTest_40300071.gcode (129.6 KB)
So I made a quick and dirty 20x20 test square that will only do the bottom layer (0.20 tall) and should run well with standard luban quick print settings (at least it looked good when I loaded it) It should give people an idea which calibration locations need more tweaking. I’m going to run mine later today, hopefully it should help out.
I should state though, I’ve made it for a build area of 280x330 to match the glass I have which is narrower in the X than the build platform, but when I level the nozzle is close to the edge of the glass which is 280mm wide, scale it to 300 wide if you want the test cube to be slightly closer to the proper center (the 20x20 cube will scale as well, but this isn’t a test of the X stepper count)