They updated the github and I was correct about the pulloff being what broke the repeatable origin. So here’s an updated build.
Snapmaker_V4.5.24-SKREE_20230202.bin_20230202.bin.zip (159.5 KB)
Based on latest github controller version 4.5.24, dated 02/02/23, reverted the 1mm pull back to 3mm, and the other one that breaks turning the laser off. I’ve been using it for a bunch of tests and everything has been good. Updated to 1.15.12 manually via USB drive before flashing my firmware.
Specifically these two commits;
Keep in mind, they hard changed Y offset, I had to increase my Y origin by 7mm.