Filament failover feature Snapmaker U1

Dear Snapmaker Team,

I would like to submit a feature request for the Snapmaker U1.

One of the unique strengths of the U1 is its multi-toolhead architecture. Because the printer can already manage multiple independent toolheads, I believe it would be extremely valuable to implement an automatic filament failover feature between toolheads loaded with the same material and color.

Example:

  • Toolhead 1: Black PLA
  • Toolhead 2: Black PLA

If Toolhead 1 runs out of filament during a print, the printer could automatically switch to Toolhead 2 and continue printing without user intervention.

This feature would provide several benefits:

  • Allow very long prints to continue without interruption.
  • Reduce the risk of failed prints caused by filament depletion.
  • Make better use of partially used filament spools.
  • Offer a competitive advantage compared to other multi-material systems.
  • Take advantage of the U1’s unique multi-toolhead design.

Since the printer already supports multiple independently loaded toolheads, this seems like a natural capability that could potentially be implemented through firmware and slicer integration.

I believe many U1 users would find this feature extremely useful, especially for long-duration prints and production workflows.

Thank you for your time and for the continued development of the Snapmaker U1.

Best regards,

1 Like

The U1 already does this. I’m not at home at the moment so can’t check exactly, but it is one of the preferences on the control panel. I have used this facility myself.

I’m moving this thread to U1 firmware.

1 Like

Settings > Print Preferences > Auto Refill

2 Likes

…and there is even an option to use a different color.

1 Like

The OP (or mods) should mark ColdCoffee’s post as the solution. I can’t do that myself.

@Omar_Ortega

1 Like

does auto refill trigger mid-layer or only at a toolchange? it’d be rough mid-wall lol

1 Like

It triggers when the filament runs out – can’t do anything else!

You don’t have to have auto-refill turned on, but if you don’t, you need to make sure the filament won’t run out or the print will pause just the same (and then suffer the consequences of cooling down).

ah so it fires whenever it runs out, mid-wall and all. the cooldown after a paused print is the rough part

What else could it do?

1 Like