I am using the A250.
The filament does not settle on the right side of the print bed.
It prints fine in the area where the auto-leveling is done.
The first layer used a raft to increase the amount of filament, but it fails, as shown in the photo.The Print Sheet is new.
This is why I can’t print large parts at all.
This is a very big problem for me and I am having trouble selling products.
The right side of the print bed and the back side of the print bed are not automatically leveled and I would like to see this fixed.
The print bed may be severely warped as a possible cause. I’ll ask support to replace the part.
The second problem is that the right side and the back side of the print bed are not adjusted automatically.
The area in the yellow frame in the picture is out of the range of the level adjustment. I would like the level to be adjusted as close to the edge as possible by avoiding the screw holes as shown in the red circle.