I need help i have failed a few times on the jeep project with the full body print. The PLA + silk stops printing and the gears eat away at the filament. There is some stringing around the extruder but not much. I will attach settings in pictures. Artisan [20230516_134506] [20230516_134514] [168…

There are a few topics about in the forum. I suggest to print the wedge and see if it helps. [image] [First Batch Shipped Out] FAQs of Dual Extrusion 3D Printing Module for Snapmaker 2.0 Snapmaker 2.0 Hallo, @brewery.chump0x Klar teile ich es mit Dir / Euch. Anbei die S…

Try printing and installing the wedge. I think and hope it will solve your issue. https://forum.snapmaker.com/t/dual-extruder-left-feeding-gear-issue/29582?u=ftoons

…and also be aware of the heat creep problem some users have: [image] Dual Extrusion Head: Heat creep discussion thread Snapmaker 2.0 Hi folks, on facebook (and I seem to remember here also) there are a few users assuming that they suffer from heat creep, some (here a pic…

Thanks for the hint with the wedge. There a a small rubber part to keep the flap closed. I added some tapes below this rubber block to push a little bit more. Hope that Snapmaker provides a solution for that problem. From my point of view this is not propper designed.

I am having the same issue. I sent in a support ticket. Very frustrating, this seems like a design flaw. A printed workaround is an unsatisfactory solution for a machine in this price range. Wish me luck getting the wedges to print, I am having issues with both sides. Thanks, Chad

As written here: [image] Dual extruder clogging and new "Replacement Kit for Snapmaker Dual Extrusion 3D Printing Module" Snapmaker Artisan Check your emails, there should be a email to all users with affected double extruder with a coupon code to get the replacementkit fo…

Dual extruder feed issues

Artisan (3-in-1)

xchrisd November 10, 2023, 6:22pm 7

As written here:

Topic		Replies	Views
Snapmaker 2 Dual Extruder Issues Snapmaker 2.0 (3-in-1)	17	2944	October 27, 2025
Problems with Dual Extruder Snapmaker 2.0 (3-in-1)	5	1178	June 7, 2023
Dual Extrusion Head: Heat creep discussion thread Snapmaker 2.0 (3-in-1)	169	10201	February 26, 2024
Dual extruder upgrade kit installed: Left nozzle still plugs up Snapmaker 2.0 (3-in-1) Dual-extruder	13	750	September 13, 2023
Artisan - Dual 3D - Consistent Left Side Fail - Need Expert Eyes Artisan (3-in-1)	9	812	May 29, 2023

Dual extruder feed issues

Related topics