You can “load” the info from either side…the printer or the software side. Just cuz you put in info in the printer doesn’t mean the software knows what it is. BUT in the software side ONLY IF you select the “sync” what is in the printer on the individual heads will it populate that in to the software. It doesn’t do it automatically and is therefore only a reference in the Device tab for what you have manually entered in the machine side. If you don’t do the sync you have to manually create the filament option in the software side and it can be whatever you want it to process…it may or may not match what you manually did on the machine side unless you make sure to match them. Without RFID on the filaments you have to do some manual work on both sides of the situation. So if your process is to load the filament info in to the machine like it wants, then you must do what Zoe_M says to do in the software to make the software match what the machine sees, otherwise you have to also manually create it in the software to match the info shown in the Device tab info. It’s not really complicated and gives user control over things.