Von meinem Snapmaker A350 2.0 scheint das Display einen Defekt zu haben.
Auf allen vier Seitenrändern verfärbt sich das Display und die Schrift darunter ist nicht mehr zu lesen. Es hat sehr schmal angefangen und wird jetzt immer breiter.
Sieht nach einem schleichenden Displaytot aus.
Kennt das jemand?
I have the same problem for some years, since the machine was 1 year old. I reported it here but nobody else had seen the same problem.
Hi @snapsch @Boxkite
For assistance with this issue, please submit a ticket at Snapmaker Support: https://snapmaker.formcrafts.com/support-ticket or mail to support@snapmaker.com
Our technical team will promptly diagnose the problem and assist you in resolving it. Thank you.
Hello Sherry.
That’s a wonderful and very interesting offer (Irony turned off).
However, I’m fed up with the hassle and frustration with them. After their last solution to the problem and the promise that it could only be resolved through a lawyer, every line with them is a waste of time.
Snapmaker is a case for the scrap heap.
Meanwhile, 5 defective axes, crashing controller and a defective power supply.
