CNC mode, z axis levelling

[xchrisd]

This is what you are looking for, unfortunately its no ready to run solution:

Tutorial on Flat Milling the Wasteboard

Hey guys, I spent quite a bit of time trying to figure out how to level my CNC bed. I was under the assumption that it would come levelled or there would be some auto-levelling mechanism, but there isn’t. I went through a few failed jobs before finally deciding I needed to figure out how to level my bed. Since I spent a day getting this to work, I figured I would document it for anyone else who might be facing the same issues as me. I have the step by step tutorial with pictures here, but here’…

Autoleveling and CNC journey

I decided to add autoleveling to snapmaker for cnc, I don’t have a problem milling pcbs but I would like to make the process easier. Right now I can mill a board in 1 shot correctly, but it’s slow and loud due to having to move at 6% speed, I’ve attached a picture of the results below: [20200409_220417] [image] This is a good result but it could be better, namely if there was autoleveling, I could move faster and also use isolation routing. Based off Lubans source code I’m trying to figure …