Calibration Assistance Needed

[xchrisd]

I guess you are getting too hot at the overhangs because of your small print surface.
Have a look at this:

Snapmaker Tower Tips! (Images included)

Hey all! If you’ve tried to make a small tower with the snapmaker, you;ve probably noticed the walls look terrible and it isn’t setting properly. [Album] Imgur [Imgur] Figure 1: It’s difficult to see, however, the print has unevent sides and caved in sections. What causes this? This is caused by the nozzle never having time to …

Print less hot, slower or a bigger model or tower