Bridging Issue when printing

[xchrisd]

Maybe this topic helps you a bit:

3d Print Guide_Walk Through

First of all, congratulations to a great machine! If you have any suggestions to this topic, feel free to send me a PM! You are new to 3d printing?- Be patient. The whole thing is very complex and just little adjustments will make the difference from failed to pretty prints. Start with easy, little things to create (1-3hours i would suggest) . Going to print the first time and then getting a 24h print on, maybe failes. There is a lot to learn, if it didn´t work for a long time, cool off a bi…

What filament do you use?- If its the snapmaker filament try to dehumidify it or buy a new spool from another company.

Try the temp tower under section 4, there is a gcode to run.- Please be sure to switch the machine off if there is a collision or something (no waranty for the gcode, but it worked a long time ago).

There should be some bridging parameters to set in cura, have a look about.
I use Simplify3d so no fast answer, sry.

Hope this helps!