Advice for the New Guy?

[xchrisd]

Temp. Tower, section 4. FINETUNE YOUR SOFTWARE SETTINGS TEST-SECTION

3d Print Guide_Walk Through

First of all, congratulations to a great machine! If you have any suggestions to this topic, feel free to send me a PM! You are new to 3d printing?- Be patient. The whole thing is very complex and just little adjustments will make the difference from failed to pretty prints. Start with easy, little things to create (1-3hours i would suggest) . Going to print the first time and then getting a 24h print on, maybe failes. There is a lot to learn, if it didn´t work for a long time, cool off a bi…

@iAlreadyLost

small gaps in the wing panels

I would suggest to calibrate your k-factor (linear advance), the most people in the forum use a value between 0,08 and 0,1 (if you do the test from the following link, you have to edit the gcode, the "K"´s have to be small “k”, because of firmware!!)

Linear Advance Calibration Pattern