Accurate, Repeatable Laser Guide

[Skreelink]

The guide is a bit dated, it can be easier to use a square instead of a dot, measure to the edge, and subtract that way.

Full Lightburn Control Guide

That’s very similar to mine. I was going to say if just pulsing a dot is a bit finicky (seems to be with the latest luban, the old version was better) you could draw a 10x10 square 10mm from the origin and run it. Then you could just measure to the lines. I’ll get an example this afternoon after work. EDIT: Example box, this is how to set it up in Luban. [Screenshot 2022-10-26 165838] The results. [PXL_20221026_215400324] I do have my corner jigs on, but to find your origin, line it up wi…

The main thread is for making everything fully automated so repeating projects is simple.

Full Lightburn Control Guide

So… After a lot of testing… It’s been awhile since I’ve done a guide, and this one was a long time coming. This guide will allow you to do your entire project in Lightburn, and (if connected via USB) run it directly from Lightburn. Letting you skip Luban or using the USB drive entirely. A quick note, this guide, like most of mine, will assume you have some experience with the machine. As always, feel free to ask questions and I’ll try filling in any gaps you find. I’ll be posting the setup I u…