Printhead Settings in Cura

Snapmaker J1/J1s
1

Hi All,

Does anyone know the proper Printhead Settings in Cura so that one can use the “one-at-a-time” mode without risking a collision with objects?

To be clear, I can set this print mode in Cura and it displays the shadow around the objects. However, I don’t know how these limits were determined.

This is what I have in the printer config in Cura

image
image682×268 14.7 KB

This is how my print bed looks like after adding 13 copies of the same object and asking Cura to arrange them on the plate.

image
image1084×646 179 KB

I have the feeling this is going to crash… especially on the area with overlaps. And I’m not sure about the dimensions X min/max Y min/max and Gantry Height.

Any advice?

Thanks in advance.
Cheers,