I have 4 printers.
Bambu Laps A1
Bambu H2D
Creality K2 Pro
Snapmaker U1
I decided to test each printer with the toaster test. All the printers except the U1 handled it perfectly. The U1 failed, I suspect I need to calibrate the printer better, something I did not need to do with the other printers.
Has anyone else printed this toaster, and if so how were your results? I will try to post pictures later today.
The Torture Toaster by Clockspring | Download free STL model | Printables.com
Interesting. I have a couple friends with Bambu A1 minis, and we’ve been comparing prints. I’ll give this one a try on my Original.
How did the U1 fail exactly? That would be helpful information.
I’m trying it now on Snorca @ .2 Standard, no brim.
Bambu Basic PLA on toolhead #2
Latest firmware v1.0
Basic printer calibration
Auto bed leveling
I’ll report in just over 5 hours. Update: It printed great, no failure
I would suggest looking at your filament, your slicer settings, firmware, run another calibration, and then try again. Perhaps try a different toolhead…