How to protect the power module from dust?

[brent113]

@Jesi15 did the design and posted it on her thingiverse:

Snapmaker 2 Enclosure Exhaust Hose Adapters by jesiscrivner

Printed with 100% fill, it’s quite substantial and feels very sturdy.

Enclosure dust escaping - possible fix (maybe)

@Nazar, parts came early so @brent113 and I finished the exhaust build tonight. We built a window mount system that we can remove if we so desire. The board is plywood sealed with polyurethane to reduce the potential for weather damage, in addition we adhered coroplast onto the exterior surface so that the wood was not in direct contact with weather. We then ran high-density foam weatherstrip tape on the edges to help seal it up and prevent wind and water intrusion as we live in Oregon and that…