Guide: Easier Titanium Coverage for Tile

[Skreelink]

I’ve had a repeatable laser origin guide for awhile now found here;

Accurate, Repeatable Laser Guide

My rotary guide (found here) seemed to be well received, so I’m going to move onto the laser. This guide will be a bit shorter, as it’s not too involved, but is mostly to help increase repeatability, accuracy, and quality of your laser projects. Likely any machinist will say a repeatable, accurate origin is a key component in quality production. You gotta know exactly where you start to know where you’re gonna end right? I know the snapmaker method is just eyeball it, be it with a mark and lini…

Though it’s a bit dated and is a bit easier using the box method with some additional info here;

Full Lightburn Control Guide

That’s very similar to mine. I was going to say if just pulsing a dot is a bit finicky (seems to be with the latest luban, the old version was better) you could draw a 10x10 square 10mm from the origin and run it. Then you could just measure to the lines. I’ll get an example this afternoon after work. EDIT: Example box, this is how to set it up in Luban. [Screenshot 2022-10-26 165838] The results. [PXL_20221026_215400324] I do have my corner jigs on, but to find your origin, line it up wi…

To realign, all I have to do is plunk it in the corner everytime.